Gel Application

STEP 1: Apply Ultra Adhesion Bonding Gel very sparingly to the nail surface from the cuticle out to the free edge. You do this buy picking up a very small amount of product onto your gel brush and brushing it into the nail using at least 8-10 strokes. After applying a very thin layer of Bonding Gel, the nail surface should have a dull grainy finish. Too much Bonding Gel will cause nails to lift or peel. If surface appears "wet or shiny” too much has been applied.  STEP 2: Cure Nails with UV Light For 90 Seconds, DO NOT remove sticky residual layer.

STEP 3: Using a Gel Brush, apply (like polish) a thin layer of Sculpture, Builder, or Soakind UV Gel to the nail surface. Cap the free edge by lightly brushing the product along the sides and end of the free edge, Gel on the surrounding skin or cuticles will cause lifting. Wipe off any gel on surrounding skin with a
Cuticle Pusher or Orangewood Stick.

STEP 4: Set under UV light for 2-3 minutes. Repeat Step 3 & 4 (once).

STEP 5: (optional) Apply Gel Polish using a gel application brush apply one thin layer of Gel Polish, pay close attention to the cuticle area and be sure to cap the free edge of the nail. Gel on the surrounding skin or cuticles will cause lifting. Wipe off any gel on surrounding skin with a Cuticle Pusher or Orangewood Stick, set
under UV light for 2-3 minutes.

STEP 6: Apply Mega Gloss Sealer Gel to give a glass like finish. Set under UV Lamp for 2 minutes. Wipe clean with Gel Residue Remover. Clean brush with Lemon Brush Cleaner.